Air filter (slide out)
Fig.26
Remove the screw and take the air inlet grille down 
Fig.27
Remove the air filter out from the grille
Fig.28
Power cord
Band
Fig.29
Fig.30
CARE AND MAINTENANCE
CARE AND MAINTENANCE
IMPORTANT:
1)Be sure to unplug the unit before cleaning or servicing.
2)Do not use gasoline, thinner or other chemicals to clean the unit.
3)Do not wash the unit directly under a tap or using a hose. It may cause electrical danger.
4)If the power cord is damaged, it should be repaired by manufacturer or its agency.
1.Air filter
-Clean the air filter at least once every two weeks to prevent inferior fan operation due todust.
-Removal
This unit has two filters. Grasp the upper filter tab (Fig. 26), pull the filter ,,out,, then ,,up,,. Remove the lower filter by
loosening the screw, taking down the air inlet grille, then removing the air filter as shown in Fig. 27 & 28.
- Cleaning
Wash the air filter by immersing it gently in warm water (about 104°F/40°C) with a neutral detergent. Rinse the filter and dry it in a shady place.
- Mounting
Insert the upper air filter from above after cleaning, Attach the lower air filter on the air inlet grille, then install the grille by using the screw.
2. Unit enclosure
- Use a
3. Prepare unit for storage
- Remove the rubber plug at the back of the unit and attach a hose to drain outlet. Place the open end of the hose directly over the drain area in your basement floor (See Fig.23 & 24).
- Remove the plug from the bottom drain outlet, all the water in the bottom tray will drain out (See Fig.25).
- Keep the appliance running on FAN mode for half a day in a warm room to dry the appliance inside and prevent mold forming.
- Stop the appliance and unplug it, wrap the cord and bundle it with the tape(Fig.29). Remove the batteries from the remote controller.
- Clean the air filter and reinstall it.
- Unscrew the exhaust hose to the right or left and pull out for uninstallation(Fig.30)and cover the window or wall hole with the adaptor cap.
14
