26
9) Make necessary adjustments, if required,
according to the pictograms shown on the
windage/elevation knobs.The step of one click
as shown on the knobs is 10mm at 100m
distance.
10) Execute a control shot and make sure that the
aiming point of the riflescope coincides with a
hit point of the bullet (perform adjustments
once again, if necessary);
11) The zeroed position of the knobs must be fixed
(this procedure is called “to set a zero”). In
order to do so, loosen the three setscrews (11,
Fig. 4) with the hexagon key on each knob.
Turn the knob without clicks until the zero
marking coincides with the marking on the
riflescope body. Tighten the setscrews with the
same key;
12) The setscrew (10, Fig.4) stops rotation of the
knob on the “-2” or “-4” clicks position
counting from “0” position of the knob. If you
adjustment mechanism is not mechanically
locked at the “minus” position, rotate the
setscrew (10) clockwise by 4-5 full cycles. If
the screw rotates too easily, lock it with the
locking substance or paint.
The riflescope is ready for use.