NG Regulator Hose and Regulator Conversion
Tools required:
Phillips Head Screwdriver (+)
Monkey Wrench
/_ WARNING
Make sure all grill components are completely cooled and gas supply is turned off and removed from grill prior to performing the conversion.
1.Install the regulator hose (short hose) to the end of the regulator marked "OUT." Install the brass connector to the other end of the regulator marked "IN." (If regulator, hose, and brass connector are
2.Turn all knobs to OFF. Turn off LP gas supply and remove the LP cylinder from the grill cart. Remove the brass adapter of the LP regulator from the manifold with a wrench.
3. Install the NG regulator hose to the manifold and secure using a wrench.
4.Remove two screws and washers from the regulator then tighten NG regulator on the right side panel from inside to outside.
15
