Notes on Installation
Disconnect negative battery terminal before starting installation. Consult the vehicle's owner's manual for proper instruction.
The unit is designed for a 12Volt DC negative ground operation system only. Before Installing the unit, make sure your vehicle is a 12Volt DC negative ground system.
Be sure to connect the leads according to the diagram. Incorrect connections may cause the unit to malfunction or damage the vehicle's electrical system.
Be sure to connect the negative
The unit is only designed for use with 4 speakers. Do not combine output for use with 2 speakers. Do not ground negative speaker leads to the chassis ground.
Make sure all of the connections are completely correct before turning on your unit.
When replacing the fuse(s), the replacement must be of the same amperage as shown on the fuse holder.
Do not block vents or heater panels. Blocking them will cause heat to build up inside and may result in fire.
After completing the installation and before operating the unit, reconnect the battery. Then press the (RESET) button with a pointed object, such as a
Before You Install
Automotive audio equipment installations can be troublesome at times, even to the most experienced of installation technicians. If you are not confident working with electrical wiring, removing and reinstalling interior panels, carpeting, dashboards or other components of your vehicle, please call your dealer in order to have the unit professionally installed.
transport screws
IMPORTANT :
Due to protection of CD Mechanism, the two small transport screws on the top of the unit must be released before installing the unit.
Otherwise, the CD Mechanism can not be working properly.
Remove the Old Unit from the Dashboard
1.Remove front control panel.
2.Slightly insert release keys into the slot and
gently to release.
3. Separate the holder from the unit. Keep release keys in a safe place as you may need for future removal of unit.
RELEASE KEY
RELEASE KEY
2