
Using the Flash
BShooting When Lighting Is Poor and the Flash Is Disabled (W)
•Use of a tripod is recommended to stabilize the camera during shooting and avoid the effects of camera shake. Turn vibration reduction (A105) off when using a tripod.
•The Eindicator is displayed when the camera automatically increases sensitivity. Pictures taken when Eis displayed may be slightly mottled.
•When Eis displayed and higher sensitivity is applied, noise reduction may be automatically applied as pictures taken are recorded; results in increased recording times.
BNote on Using the Flash
When using the flash at a
CThe Flash Indicator and Flash Lamp
The flash indicator and flash lamp indicate flash status when the
• On: Flash will fire when picture is taken.
•Blinks: Flash charging. Wait a few seconds and try
again.
• Off: Flash will not fire when picture is taken.
If the battery is low after pictures are taken using the flash, the monitor display will turn off, and remain off, and the flash lamp will blink until the flash is fully charged.
CThe Flash Mode Setting
The default setting is U(auto), except in some scene modes and
If the flash mode is adjusted in any scene mode or
C
This camera uses advanced
Mode Auto Playback: and Photography Basic
31