Nikon SB-16 instruction manual Load the batteries into Holder, Replace the holder, Close the lid

5 Load the batteries into

. the holder.

Load four 1.5V AA-type penlight alkaline-manganese cells or 1.2V rechargeable NiCd batteries into the holder, making sure that the positive and negative (+ and -) terminals match the diagrams on the holder.

Notes :

1)Use of manganese batteries is not recom - mended because their power is insufficient for operating the S8 -16 at full capacity.

2)Do not mix brands or types of batteries. Also, avoid mixing new and old batteries since proper performance will not be obtained.

6. Replace the holder.

First, make sure the power switch

@of the flash unit is at the " off" position ; then put the holder back into the chamber, so that the slots at both sides of the holder are aligned with the guide rails inside the battery chamber.

7. Close the lid.

While applying pressure to the battery holder with your finger, slide the lid as far as it will go until it clicks into place .

9