3. Projecting an Image (Basic Operation)

￿After Use

Preparation: Make sure that the projector is turned off.

1.Unplug the power cable.

2.Disconnect any other cables.

3.Retract adjustable tilt feet if extended.

4.Cover the lens with the lens cap.

5.Put the projector and accessories in the supplied soft case.

Place the projector in the soft case with the lens facing upward as shown below. This is to prevent the lens from damage.

Insert the projector with the lens facing upward

NOTE: When placing the projector in the soft case, retract the tilt feet and the rear feet. Failure to do so may case damage to the projector.

CAUTION:

Use caution when putting the projector in the soft case immediately after the projector has been operating. The projector cabinet is hot.

29