Installation of the Speaker and Grille for New or Existing Construction
corner, go around the speaker, pushing the grille in a little bit each time. You should be gentle, the aluminum grille can be easi- ly bent out of shape. The speaker will have an absolutely flush appearance when it is fully in place.
Speaker Phase
Speaker wire has two conductors. One conductor is attached to the negative
If you make a mistake, one speaker will be playing
1.Stand half way between the two speakers.
2.Play some music with the amplifier or radio set to Mono.
3.Listen to the richness of the bass and the loudness of the sound.
4.Turn off the amplifier and reverse the connections on one amplifier channel only.
5.Repeat the listening test with the same setting of the volume control. When the sound has a richer bass and is slightly louder the speakers are working together or
Operation
Listening at Higher Volumes
It requires more power to achieve a rea- sonable volume of sound in a large room than it does in a small room. It is possi- ble (even if you are not a teenager) to turn the volume so high that the amplifi- er runs out of power. This creates “clip- ping” distortion.
Clipping distortion makes treble sound very harsh and unmusical. When you hear harsh sounding treble from any good speaker, turn the volume down immedi- ately! Those harsh sounds are masking some much more powerful
Cleaning
You can clean the speaker with a damp- ened soft cloth or paper towel. If the speaker is mounted high up on a wall or ceiling, use a broom to gently brush it off.
Operation
19 |
| 20 |
|
|
|