INSTALLATION (CONTINUED)
STEP 4 – MOUNTING A MICROFLASHER TO A/V COMPONENTS
Make sure all of your remote controls have batteries and that they are able to operate the A/V com- ponents. Locate a place for the remote control that is within arm’s length of the A/V components, yet cannot directly control them. Place the
Hold the MicroFlasher four inches in front of the remote sensor window on the A/V component’s front panel. Press buttons on the remote control while watching the front panel of the A/V compo- nent. When the component responds repeatedly to the commands, peel off the protective backing on the MicroFlasher and place the MicroFlasher in that location.
If the A/V component’s remote sensor is not clearly marked, slowly move the MicroFlasher over the win-
dow of the A/V component while pushing buttons on the remote control until you get a response (Figure 7).
Repeat this procedure for each A/V component you
wish to control.
When the A/V component responds repeatedly, peel off the protective backing on the MicroFlasher and place the MicroFlasher in that location.
NILES AUDIO CORPORATION – | 7 |
