R E M O T E
RCA3
Remote Control
Anywhere! Kit
TABLE OF CONTENTS
Introduction 2
Getting
Started 4
Installation 4
System Operation 13
Optional Accessories 14
Running Sensor
Cable in New
Construction 16
Concealing
Sensor Cable
in Existing
Walls 18
Specifications 22
C O N T R O L A N Y W H E R E ! K I T
WARNING – To prevent possible injury, the following basic safety precautions should be observed in the installation and use of your Remote Control Anywhere Kit.
1.Read through the entire manual – Before attempting any installation, read this manual thoroughly and keep it for future reference.
2.Avoid contact with all high voltage electrical wiring and equipment!
3.Keep away from water and moisture – Never use or install electronic products near water, ie., near a bathtub, sink, washing machine, in a wet basement, near a swim- ming pool, or anywhere else the product may be exposed to water or moisture.
4.Power supply cord protection – Do not run the power cord where it may be subject to wear or abuse. Do not allow anything to rest on or roll over the power cord which may damage it.
6.Lightning – It is suggested that you remove the power supply from the wall if your system will not be used for long periods of time. Power surges due to lightning strikes may damage your equipment.
7.Check your local building and electrical codes – There may be specific requirements regarding running low voltage in your area.
