Niles Audio manual INSTALLATION EXAMPLES USING THE SAS-1, Voltage-Activated Mode

NOTE: IF YOU ARE USING THE SAS-1 TO SIMULTANEOUSLY SWITCH BOTH LINE-LEVEL AUDIO AND VIDEO SIGNALS, AND WANT THE UNIT TO TRIGGER FROM EITHER SOURCE, MOVE BOTH THE “A” SWITCH AND THE “V” SWITCH UP. IF YOU WANT THE SAS-1 TO TRIGGER FROM EITHER SPEAKER- LEVEL OR VIDEO SIGNALS, SLIDE BOTH THE “S” SWITCH AND THE “V” SWITCH UP. IF YOU MOVE ALL THREE SWITCHES UP, THEN THE SAS-1 WILL TRIGGER FROM ANY OF THE THREE SOURCES

VOLTAGE-ACTIVATED MODE

In this mode, the SAS-1 switches from A to B when 5 to 24 Volts (AC or DC) is applied to the “CONTROL IN” jack. This is not affected by the settings of the DIP switches

INSTALLATION EXAMPLES USING THE SAS-1

USING AN SAS-1 VIDEO SIGNAL ACTIVATED SWITCH.

FIGURE 1

			���������������
�����������				���������������
�����
					���������������
	�				�
��������					������
�����������	�				�
		�������
				�������
				��
�������	�����				�����
�����					��������������
�����������					�������������
					�����
�	�	�	�	�	�

���������������

���������������

���������������

4