Niles Audio SSVC-6, SSVC-4, SSVC-2 Installation, Type of Speaker Wire, Avoiding Interference

S P E A K E R S E L E C T I O N / V O L U M E C O N T R O L S Y S T E M

Type of Speaker Wire

For most applications, we recommend you use 16 or 18 gauge stranded copper speaker wire for the SSVC-2/4/6 con- nections. For wiring runs longer than 80 feet, 14 gauge wire is recommended. Using speaker wire larger than 14 gauge for SSVC connections is not recommended—the wire may not fit into the connectors. Never use solid-core, aluminum, or “Romex” type wire with the speaker selector. When running speaker wires inside walls, most states and municipalities in the U.S. specify that you must use a special type of speaker wire. Usually, the requirement is that the wire has a specific “CL” fire rating, such as “CL-2” or “CL-3”. Consult your Niles dealer, building contractor, or local building and inspection department if unsure about which type of wire is best for your application.

Avoiding Interference

Speaker wires can act as an antenna for electrical noise. Locating speaker wires too close to a light dimmer or switch may cause a “buzzing” or “popping” sound to be heard thought the speakers. If you must locate the SSVC series wiring near electrical devices, route the speaker wires several feet away from the electrical wiring.

S P E A K E R S E L E C T I O N / V O L U M E C O N T R O L S Y S T E M

Installation

1.Select a convenient location for the SSVC-2/4/6 .

2.Run all the necessary wiring to the SSVC-2/4/6 . Label the wires for future reference. See (Figure 1).

3.Locate the connector plugs (and remove them if they are plugged in). See (Figure 2) and (Figure 4).

4.Strip 1/4" of insulation from the end of each wire. Tightly twist the end of each wire until no frayed ends remain.

SSVC-2 connector installation

a. On the SSVC-2 use a small flathead screwdriver or your thumbnail to raise the locking tabs, exposing the holes on the removable connector plug.

b. Insert each wire into the appropriate hole on the removable connector plug, and snap the locking tab down.

NOTE: To help you avoid improper installation, the connector plug is keyed.

c. Insert the smooth side of the connector plug into the smooth side of the socket. Don’t force the scalloped side of the connector plug into the smooth side of the socket. See (Figure 2).

7 8