![](/images/new-backgrounds/1042301/4230113x1.webp)
ENGLISH / A-7
DESCRIPTION OF THE BATTERY CONDITION INDICATORS
The battery condition indicator (K) consists of three lights, a green, a yellow, and a red. The voltage indication will change based on the cutoff level (standard or alternate) selected in the control unit. The battery voltage ranges for the various indications are listed below:
| Standard |
| Alternate |
Green | 34.00+ |
| 34.50+ |
Green & Yellow | |||
Yellow | |||
Yellow & Red | |||
Red | |||
Flashing Red/Cutoff | <31.00 | <32.50 |
|
NOTE: Refer to service manual for selection of alternate
INSTALL THE BATTERIES
WARNING !
Use extreme caution when working with batteries. Sulfuric acid in batteries can cause severe injury if allowed to contact the skin or eyes. Explosive hydrogen gas is vented from inside the batteries through openings in the battery caps. This gas can be ignited by any electrical arc, spark or flame.
When Servicing Batteries...
*Remove all jewelry.
*Do not smoke.
*Wear safety glasses, a rubber apron and rubber gloves.
*Work in a
*Do not allow tools to touch more than one battery terminal at a time.
CAUTION !
Electrical components in this machine can be severely damaged if the batteries are not installed and connected properly. Batteries should be installed by
1Turn the Key Switch (J) off (O) and remove the key. Then swing open the Battery Compartment Cover (16).
2Using (2) people and an appropriate lifting strap, carefully lift the batteries into the compartment tray exactly as shown. Refer to decal 56015168 battery cable layout.
3See Figure 1. Install battery cables as shown and tighten the nuts on the battery terminals.
4Install the battery boots and secure tightly to the battery cables with the supplied tie straps.
5Connect the battery pack connector to the machine connector (22) and close the battery compartment cover.
FIGURE 1
revised 10/06 | FORM NO. 56041554 - Advenger™, Advenger™ AXP / BR 600S series - |