Nilfisk-Advance America HSC 585 operating instructions Automatic-Dumpinstructions

AUTOMATIC-DUMP INSTRUCTIONS

Operation:

1.Before each use: if necessary, unscrew the stainless steel filter inside the recovery tank and clean it. Also make sure the float in the recovery tank is clean.

2.Attach a garden hose to the automatic pump-out fitting on the back of the base of the machine (refer to illustration below).

3.Run the other end of the hose into a drain.

4.Turn on the switch for the automatic pump-out (switch is located on the switch panel on the top of the machine).

NOTE: the pump out pump is ‘self-priming.’ When there is water in the recovery tank, it will automatically pump out.

After each job, run clear water though the automatic pump-out to wash out any chemical residue. Remove and clean the stainless steel filter in the back of the tank. Reinstall the filter once it is clean. Empty and clean the recovery tank. Disconnect and roll up the dump hose. Clean and dry the machine and accessories.

DANGER: DO NOT USE SOLVENTS, OR ANY CHEMICALS THAT MAY BE FLAMMABLE, EXPLOSIVE, OR COMBUSTIBLE.

CAUTION: always use a defoamer in the recovery tank to prevent water or foam from entering the vacuum motor.

AUTOMATIC-DUMP

HosePower

Connection Prime

Valve

Dump Power

Pump Prime

Pedal

11600205211REVA -9-