7.2.2Replacing the waste bag
Only after picking up nonhazardous dust or dust with MAC values >1 mg/m³.
7.2.3 Replacing the filter bag
During the following work, en- sure that dust is not unnecessarily spread around. Wear a P2 breath- ing mask.
| 2 |
1 | 1 |
3 |
1 |
ATTIX
1.Remove the upper section of cleaner from the dirt tank.
2.Open the retaining clamps
(1) and remove the interme- diate ring (2) from the tank.
3.Close the waste bag using the cable binder (3).
4.Dispose of the dirt in accord- ance with legal regulations.
5.Insert a new filter bag into the cleaned tank as described in the instructions enclosed.
1.Open the retaining clamps and remove the upper section of the cleaner from the dirt tank.
2.Carefully remove the filter bag connection from the inlet fitting.
3.Close the filter bag connection with the slide.
4.Dispose of the filter bag in ac- cordance with legal regulations.
5.Place a new filter bag into the cleaned tank as described in the instructions (printed on the filter bag)
IMPORTANT: Press the filter bag connection on the inlet fit- ting as far as possible.
7.2.4 Emptying the dirt tank
Only after picking up harmless dust with- out a filter bag.
To empty the dirt tank after picking up liquids: remove
the intermediate ring as a proper seal is only ensured during suction. After emptying the tank: clean the rim of the tank and the seals in the intermediate ring and the upper section of cleaner before refitting them.
If the seal or groove is dirty or dam- aged, the suction performance will be reduced.
Before reinserting the suction hose: clean the inlet fitting and hose col- lar.
| 2 |
1 | 1 |
| 3 |
1.Remove the upper section of cleaner from the dirt tank.
2.Open the retaining clamps
(1)and remove the interme- diate ring (2) from the tank.
3.Pull the lever in the handle
(3)upwards and tilt the tank.
4.Tip out the collected dirt.
5.Dispose of the dirt in accord- ance with legal regulations.
or:
3.Open the tank locks (4).
4.Use the handles (5) to lift the tank out of the frame.
9
