SSE 350
Control/Operation
Hook in fresh water bag:
•Hook tab of fresh water bag on left side of tank opening seen in direction of travel. (Fig. 3/1)
•Separate cover from suction hoses and flush thoroughly.
•Flush suction sieve for cleaning agent (Fig. 4/2) and sieve in cover with clean water.
•Clean machine and suction lips with damp cloth. Clean brushes and pads with water if necessary.
3.4Troubleshooting
CAUTION!
Always disconnect mains plug/ battery connection before working on machine!
Fault
Machine does not run
•To clean pads or brushes, tilt machine back onto handle.
•Pull brush and driving disk off mount and wash. (Fig. 11)
•When remounting, make sure that brush or driving disk engages in groove.
3.3.3 Changing suction nozzles
•Remove tank.
•Tilt machine back onto handle.
•Press in clips at left and right on
WARNING!
Only carry out maintenance and repair work described in the operating instructions.
Always leave servicing and repair work, especially the elimination of electrical faults, to the Alto Customer Service technicians or to an authorised specialist.Fachkraft.
Cause
>Mains/battery plug not connected.
>Fuse blown or
>Overheating protection has been activated.
>Power supply interrupted.
suction nozzles. (Fig. 10/1)
•Pull off suction nozzles downward. (Fig. 10/2)
•Position new suction nozzles and audibly engage with light pressure.
3.3.4 Changing brushes
•Remove tank.
•Tilt machine back onto handle.
•Release brushes at left and right and pull off (remove by turning).
3.4.1Warranty
Remedy
•Plug in mains/battery plug.
•Check fuse or
•Allow motor to cool.
•Have supply line checked by electrician.
Insufficient suction | > Suction nozzle plugged. | • | Eliminate plugging. |
| > Connection of tank cover open. | • | Connect suction hose. |
| > Tank cover not properly fitted or | • Fit tank cover properly or replace | |
| seal defective. |
| seal. |
| > Suction sieve in tank cover | • Rinse sieve with clean water. | |
| plugged. |
|
|
| > Drain plug on tank not | • Check seal, press on plug firmly. | |
| completely closed. |
|
|
|
|
| |
Stripes form | > Suction lips dirty or worn. | • Clean or replace suction lips. |
Insufficient supply of cleaning | > Lines or nozzles plugged with |
agent | cleaning agent. |
•Flush fresh water tank and line system. (Chap. 3.3.1)
10