SSE 350
After draining:
•Press drain plug back into opening. (Fig. 8/4)
•Flush sieve in tank cover with clean water if dirty. (Fig. )
•Check suction lips on suction nozzle for dirt deposits (paper, cigarette residues, sand etc.) before machine is refilled and put into operation again.
2.4After use
•Set ON/OFF switch to ‘OFF’ position. (Fig. 7)
•Set
•Raise suction nozzles. (Fig. 5/3)
•Pull out mains plug.
•Wind up power cable.
•Store machine in
3 | Servicing/Maintenance |
| |
3.1 | Important safety notes | WARNING! | Always leave servicing and repair |
|
| Only carry out maintenance and | work, especially the elimination of |
CAUTION! | repair work described in the | electrical faults, to the Alto | |
Always disconnect mains plug/ | operating instructions.Überlassen | Customer Service staff or to an | |
battery connection before working | Sie Service- und Reparaturarbeiten, | authorised specialist. | |
on machine! |
|
|
3.2Maintenance schedule
After every use | weekly | if needed |
Flush pump system with clean water
Clean fresh water and dirty water tank
Clean lower machine section with a damp cloth
Inspect wiping lips for wear and clean or replace if necessary
Replace brush roller
Servicing/Maintenance Control/Operation
3.3Maintenance work
3.3.1 Flushing pump system
•Fill fresh water bag drained of cleaning agent with approx. 1 l of clean water.
•Set
•Catch exiting clean water of vacuum up with machine.
3.3.2Cleaning fresh water and dirty water tank
•Remove tank from automatic cleaning machine before cleaning and draining dirty and fresh water.
Drain dirty water tank:
•Pull of drain plug.
•Pour out dirty water via housing corner.
Remove fresh water bag:
•Slightly pull up tab of fresh water bag (Fig. 3/1) and unhook from edge.
•Lay bag in tank and remove through large tank opening. (Fig. 3/2)
•Drain fresh water tank and flush with fresh water.
•If necessary, hang up bag to dry and thoroughly flush tank.
9