Connecting the Mediamaster
Connecting to the TV without SCART
• Remove the aerial lead from your TV and connect this to the TV AERIAL input socket on the Mediamaster.
• Connect an RF cable from the TV/VCR output on the Media- master to the RF input socket on the TV.
• Switch on your TV, plug in and switch on your Mediamaster.
• Select a programme number on the TV that is not currently used for other TV channels.
• Follow the instructions in your TV manual to tune the TV to pick up the First time installation menu.
• Follow the instructions in your TV manual to store this chan- | RF | |
nel. | ||
| ||
• When the First time installation menu is visible, press the se- |
| |
lect button on the Mediamasters remote control to start the |
| |
installation procedure. |
| |
If the picture quality is bad you can later change the predefined |
| |
UHF channel 43 to any other figure between 21 and 69. You will |
| |
also have to tune your TV to the same (= the new) channel |
| |
number. Please see RF modulator output channel setting on |
| |
page 20. |
|
Connecting a HiFi system
•Connect an RCA/Cinch stereo cable ( phono ) from the AUDIO L R sockets on the Mediamaster to the LINE,
•If available you can connect an RCA/Cinch single cable from the DIGITAL AUDIO socket on the Mediamaster to a HiFi sys- tem equipped with digital audio input. This output is also used for connection to an external Dolby™ digital decoder.
Note: To avoid interference you must use screened audio cables. Never connect digital output to any analogue input.
It is always advisable to consult your HiFi instruction book.
GB 9
