Nokia 6190 Attaching the battery when using optional analog module, Charging your new battery

Attaching the battery when using optional analog module

1) Place the analog module on the back of the phone

2) Slide the module toward the top of the phone until it clicks into place

3) Place the battery on top of the analog module

4)Slide the battery toward the top of the phone until it clicks into place

Charging your new battery

Your phone is powered by a rechargeable Li-Ion or NiMH battery, which should be charged for 24 hours without interruption. Note that a new NiMH battery’s full performance is achieved only after two or three complete charge and discharge cycles.

Note: Use only batteries approved by the phone manufacturer and recharge your battery only with the chargers approved by the manufacturer.

Also, see “Important Battery Information” on page 98 for important battery usage information and “Talk and Standby Times” on page 90 for approximate battery operation times.

With your phone on or off, simply connect the lead from the charger to the bottom of your phone or place it on a charging stand. Then connect the charger to a standard 120V AC outlet.

Note: If you have purchased an optional analog module, be sure to remove it and replace the battery before placing the phone in a charging stand. Although the phone will fit in the stand with the analog module attached, charging will not take place.

When the battery begins charging, the battery strength indicator on the right side of the display will scroll and your phone will beep once. When you

7