Nokia 9000i owner manual Records, Speed dials, Storing Dtmf tones, To store a Dtmf sequence

3-4 Records

phone numbers stored in the Tel (GSM) fields. Make sure that GSM numbers are listed in this field.

Speed dials

The Speed dials command (see Figure 3-1) lets you assign speed dials to eight phone numbers. Number 1 is reserved for calling your voice mail- box (see Chapter 4 "Telephone: Making a call - Calling your voice mailbox" on page 4-6). For in- formation on how to use the speed dials, see Chapter 13 "Phone interface: Using memory - Dialing shortcuts" on page 13-5.

To set speed dials:

•Press Speed dials in an opened contact card. All phone number fields of the contact card are shown.

‚Select a field to which you want to assign a speed dial and press Change. Select a loca- tion and press OK.

To change or remove speed dials:

•Select the speed dial you want to change or remove and press Change.

‚Move the selection frame to the location you want to use and press OK. If you want to re- move a speed dial location, choose None and press OK.

Storing DTMF tones

The Dual Tone Multi Frequency (DTMF) tones are the touch tones you hear when you make a call. DTMF tones allow you to communicate with voice mailboxes, computerized telephony sys- tems, etc. For information on how to send DTMF tones, see Chapter 4 "Telephone: Conference call

-Sending DTMF tones" on page 4-8, and Chapter 13 "Phone interface: Sending DTMF tones" on page 13-3.

If you use only DTMF tones to make a call (e.g., calling your bank for automated balance information), you can create a contact card for the DTMF contact that will facilitate the call and allow you to enter a string of numbers, such as your personal identification code.

If you use both voice and DTMF tones, you can customize an existing contact card to include the DTMF tones you will be using.

To store a DTMF sequence:

•Use the Tel field. Enter the telephone number, then one of the DTMF special characters, then the DTMF sequence. You may want to change the field label (with Change label) to recognize the DTMF contact.

‚Or, use a separate DTMF field. Add a DTMF field in the contact card and enter the DTMF sequence.

The DTMF special characters are listed in the following table:

Character	Function
* and #	May be used if the DTMF service
	requires them
p (pause)	Inserts a pause of 2.5 seconds in
	front of, or between, DTMF digits
	When the “w” character is
	stored in a sequence, the rest of
w (wait)	the sequence is not sent until
	you press Send again in the
	Telephone application.
	Table 3-1

Records

The Contacts application Record function allows you to view all communications as one of two records: a General record or an Individual record.

You can use the General record (Figure 3-2) to create a new contact card.