BASIC SETTINGS
Once you have correctly connected the Mediamaster, you also have to perform some “Basic Settings”. During this procedure, helpful information is displayed at the bottom of the menus.
Please note!
The OK button always confirms a selection within these menus, and pressing it will take you to the next step in the installation process. However, and this is important, often more than one value has to be entered in a menu. First, perform all necessary settings on the different lines. Then, confirm them all simultaneously by pressing OK.
You can always go back to the previous menu by pressing the BACK button.
Use the buttons to move upwards and downwards from one line to another. Use to change settings. You can also use the numeric buttons on the remote control to select a line in a menu and to enter numeric values.
Tuning procedure when RF connections are used
This procedure is necessary only if your Mediamaster is connected to the TV with an RF cable.
To tune your TV to the RF signal you might also need your TV manual in addition to this manual. The steps below explain what to do if you have been unable to use SCART cables in your connection.
!" Plug in your Mediamaster.
Tuning your TV to the Mediamaster.
!" Select a channel number on the TV that is not currently used for other TV channels.
!" Follow the instructions in your TV manual to tune the TV channel selector to UHF channel 43 (this is the Mediamaster’s factory preset UHF channel). If you are already using this channel, select another non occupied UHF channel between 21to 69 on the TV.
!" When you have correctly changed the UHF channel number you will see the “Welcome” menu on the TV screen. If there is interference from other channels you will have to change the chosen UHF channel.
!" Follow the instructions in your TV manual to store this UHF channel as the channel used by your Mediamaster. You will have to select this channel when you want to watch digital TV/Radio channels.
!" Once the welcome message is visible, press the OK button on the Mediamaster’s remote control to start the installation procedure.
If for some reason you have to change the RF channel later, you can do this by using “System Settings” menu further on in this manual. If you have a VCR connected it must be tuned to a different UHF channel (between 21 to 69) than the Mediamaster.
You may now proceed to “The Welcome Menu.”
GB 11
