Nokia DSL Gateway High-Speed Internet Connection manual Connecting the data cables and WLAN cards

Models: DSL Gateway High-Speed Internet Connection

1 43
Download 43 pages 34.24 Kb
Page 18
Image 18
4.3Connecting the data cables (and WLAN cards)

Nokia M/MW Gateways M1112, M1122, MW1112, MW1122, MW1324, MW1352

4.3Connecting the data cables (and WLAN cards)

Do not connect the gateway's power cord yet! WARNING

Do not connect the gateway's power cord yet!

Note

If you are using WLAN cards, note that the installation procedure described below only covers the physical installation of the WLAN cards.

Before you can use your gateway's wireless feature, you must first install Nokia C110/C111 WLAN card software on your computer. The software and installation guide are delivered with the optional Nokia C110/C111 WLAN card.

Connect the data cables

1.Connect the 8-pin Ethernet cable between the computer's Ethernet card and the gateway's Ethernet connector located in the gateway's back panel.

Steps 2 and 3 are for MW1324 only.

2.If you use a splitter with your MW1324, connect an additional DSL/HPNA cable (RJ-12) between the HPNA connector of your MW1324 and a phone wall socket after the splitter.

If you use a microfilter before each phone, you do not need to install the additional DSL/HPNA cable. In such a case, leave the HPNA connector unconnected. (The HPNA signal uses the same cable as ADSL, so no additional cabling is needed.)

3.Connect each PC in your home network to your home phoneline network (without microfilters). Your PC's must be equipped with HPNA network adapters.

4.Connect the 6-pin DSL cable between the gateway's DSL connector and your DSL phone wall socket.

16 (40)

© Nokia Networks Oy

DN01154358

 

Nokia Proprietary and Confidential

Issue 1-0 en

Page 18
Image 18
Nokia DSL Gateway High-Speed Internet Connection manual Connecting the data cables and WLAN cards, Connect the data cables