Nokia N95 manual 108, Authentication Select Normal or Secure, Wireless LAN access points

Settings

108

Prompt password — If you must enter the password every time you log in to a server, or if you do not want to save your password in the device, select Yes.

Password — A password may be needed to make a data connection, and is usually provided by the service provider.

Authentication — Select Normal or Secure.

Homepage — Depending on the access point you are setting up, enter the web address or the address of the multimedia messaging center.

Select Options > Advanced settings to change the following settings:

Network type — Select the internet protocol type to use: IPv4 or IPv6. The other settings depend on the selected network type.

Phone IP address (for IPv4 only) — Enter the IP address of your device.

DNS address — In Primary DNS address, enter the IP address of the primary DNS server. In Secondary DNS address, enter the IP address of the secondary DNS server. Contact your internet service provider to obtain these addresses.

Proxy server address — Define the address for the proxy server.

Proxy port number — Enter the proxy port number.

Copyright © 2007 Nokia. All rights reserved.

Wireless LAN access points

Follow the instructions from the wireless LAN service provider.

WLAN network name — Select Enter manually or Search for networks. If you select an existing network, WLAN network mode and WLAN security mode are determined by the settings of its access point device.

Network status — Defines whether the network name is shown.

WLAN network mode — Select Ad-hoc to create an ad hoc network and to allow devices to send and receive data directly; a wireless LAN access point device is not needed. In an ad-hoc network, all devices must use the same WLAN network name.

WLAN security mode — Select the encryption used: WEP, 802.1x (not for ad hoc networks), or WPA/WPA2. If you select Open network, no encryption is used. The WEP, 802.1x, and WPA functions can be used only if the network supports them.

WLAN security settings — Enter the settings for the selected security mode:

Security settings for WEP:

•Wep key in use — Select the WEP key number. You can create up to four WEP keys. The same settings must be entered on the wireless LAN access point device.