INSTALLATION INSTRUCTIONS
Certification and Code Requirements
The refrigerators described herein are certified un- der the latest edition of ANSI Z21.19 Standards by the American Gas Association (A.G.A.) for installa- tion in mobile home or recreational vehicle and ap- proval by the Canadian Gas Association (CGA).
Installation must be made in accordance with these standards and with the installation instructions pro- vided in this manual for the Norcold factory warranty to be in effect.
Installation must conform with local codes, or in the absence of local codes, with the following standards as applicable:
In the United States:
a. National Fuel Gas Code, ANSI Z223.1.
b.Manufactured Home Construction and Safety Standard, Title 24 CFR, Part
c.Standard for Recreational Vehicles,ANSI A119.2, latest edition.
When an external electrical energy is utilized, the refrigerator must be electrically grounded in accord- ance with local codes, or in the absence of local codes, the National electrical Code, ANSI/NFPA 70.
In Canada:
a. Current CGA B149.1 and B149.2 installation code for Propane Appliances and Equipment..
b. Current CSA Z240.4.2 installation code for Pro- pane Appliances and Equipment in Recrea- tional Vehicles.
c. Current CSA Z240.6.2/C22.2 No. 148 Electrical Requirement for Recreational Vehicles.
When installed, the appliance must be electrically grounded in accordance with the current Canadian Electrical Code C22.2 Parts 1 and 2.
Combustion Seals
Combustion seals (foam strips) are attached to the back surface of the refrigerator’s mounting flanges. These seals isolate the products of combustion from the vehicle’s living space. The seals must be con- tinuous between the wall and the mounting flanges to assure a complete combustion seal. When installing or removing the refrigerator, insure that the seals are not missing or damaged.
Lower Flange Installation
The lower mounting flange and mounting screws are located in a clear plastic bag positioned in the coils at the rear of the refrigerator. After removing the plastic bag, slide the refrigerator partially into the en- closure and attach the lower mounting flange. Install the lower mounting flange by maneuvering it under the bottom control cover and secure with the screws provided. Refer to Figure 7. Do not omit installa- tion of the lower mounting flange. This flange is part of the combustion seal.
Cut-Out Dimensions
The refrigerators certified for built installation and requires
TABLE 2
REFRIGERATOR
Model | Height | Width | Depth |
462, 463 | 52 7/8 | 23 1/2 | 24 |
482, 483 | 59 7/8 | 23 1/2 | 24 |
452,453 | 43 1/4 | 23 1/2 | 24 |
442,443 | 30 7/8 | 23 1/2 | 24 |
Figure 7
Securing the Refrigerator
Secure the refrigerator with screws through the mounting flange holes at the front of the refrigerator and the holes at floor level at the rear of the refrig- erator. Screw covers are provided to cover the front mounting flange holes.
8
