INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (refer to
page 19), follow the steps below to install the receiver and the
1. Remove the four indicated screws from the back of the
Console (87). Lift the top of the Console. Be careful not to disconnect any wires.
2.Peel the paper off the adhesive pad on the back of the receiver (A). Orient the receiver exactly as shown, and press it onto the Console (87) in the indicated location.
Connect the wire on the receiver (A) to the
(B)as shown. Unplug the indicated console wire (C) from the indicated jack (D), and plug the console wire into the
Refer to step 1 above. Reattach the top of the Console (87) with the four screws. Make sure that no wires are pinched.
Note: Any other wires that are included with the chest pulse sensor may be discarded.
1 |
Screws |
87 |
2 |
|
| D |
| C |
| B |
| A |
87 | Cylinder |
HOW TO USE THE ELLIPTICAL CROSSTRAINER
HOW TO PLUG IN THE POWER CORD
This product must be
grounded.
If it should malfunction or break down, grounding provides a path of least resistance for
electric |
|
current to reduce the risk of electric shock. This prod- |
|
uct is equipped with a cord having an equipment- |
|
grounding conductor and a grounding plug. | Plug the |
power cord into an appropriate outlet that is prop- |
|
erly installed and grounded in accordance with all local codes and ordinances. This product is for
use on a nominal
DANGER: Improper connection of the
result in an increased risk of electric shock. Check with a qualified electrician or service- man if you are in doubt as to whether the product is properly grounded. Do not modify the plug provided with the
8
