NordicTrack NATL81205.0 manual Assembly, Make sure that the power cord is unplugged

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex key and your own phillips screwdriver , wire

cutters , and rubber mallet . For help identifying the assembly hardware, see the hardware drawings below.

Nut (9)–2	Star Washer (77)–8	1” Screw (148)–4	Extension Leg
			Bolt (130)–4
Short Console		Console Bolt (78)–2
Bolt (106)–2
Pulse Bar Bolt (33)–4		Wheel Bolt (94)–2

1.Make sure that the power cord is unplugged.

With the help of a second person, carefully tip the treadmill onto its left side as shown. Partially fold the Frame (110) so the treadmill is more stable. Do not fully fold the treadmill until it is completely assembled.

Insert the two Extension Legs (102) into the base of the Uprights (69); make sure that the Extension Legs are turned so the Base Pads (99) are in the positions shown.

Attach each Extension Leg (102) with two Extension Leg Bolts (130).

1	102
	99
	110
	130
	69
	102
	99
	130

6