NordicTrack NTB58030 user manual Locknuts yet, Tighten all of the M10 Nylon Locknuts Used in steps

11.	Wrap the Cable (31) around an 89mm Pulley	11
	(26). Attach the Pulley and a Cable Trap (27) to
				31
	the Weight Carriage (10) with an M10 x 45mm	32
	Bolt (36) and an M10 Nylon Locknut (32). Make			26
	sure the Cable Trap is outside of the bracket			27
	and oriented to hold the Cable in the groove
	of the Pulley.			36
		10
12.	Wrap the Cable (31) around an 89mm Pulley	12
	(26). Attach the Pulley and a Cable Trap (27) to
	the bracket on the Lat Tower (8) with the M10 x		27	26
	75mm Bolt (40) used in step 10 and an M10
	Nylon Locknut (32). Make sure the Cable Trap		32
	is oriented to hold the Cable in the groove of
	the Pulley.
				31
				40
			8
13.	Route the Cable (31) through the Lat Tower Base	13
	(3) and around an 89mm Pulley (26). Attach the
			32 26
	Pulley to the bracket on the Lat Tower Base with
	an M10 x 45mm Bolt (36) and an M10 Nylon			36
	Locknut (32).
		31
			3
14.	Route the Cable (31) under an 89mm Pulley (26)	14
	and through the Foot Plate (13) as shown. Attach
				33
	the Pulley to the Foot Plate with an M10 x 45mm	2
				32
	Bolt (36) and an M10 Nylon Locknut (32).
	Attach the Foot Plate (13) to the Lat Tower Base	36		33
				32
	(3) with two M10 x 19mm Bolts (37) and two M10		26
	Nylon Locknuts (32). Do not tighten the		32	32
	Locknuts yet.
	Attach the Foot Plate (13) to the Bottom Crossbar	34		32
	(2) with two M10 x 94mm Bolts (34), two M10	31
				3
	Washers (33), and two M10 Nylon Locknuts (32).
	Tighten all of the M10 Nylon Locknuts (32)	37	13
	used in steps 1–14.
		9