NordicTrack NTB58030 user manual Assembly, Make Things Easier for Yourself, Locknuts yet

Models: NTB58030

1 19
Download 19 pages 33.22 Kb
Page 5
Image 5

ASSEMBLY

Make Things Easier for Yourself

Everything in this manual is designed to ensure that the weight rack can be assembled success- fully by anyone. However, it is important to real- ize that the versatile weight rack has many parts and that the assembly process will take time.

Most people find that by setting aside plenty of time, assembly will go smoothly.

Before beginning assembly, carefully read the following information and instructions:

Assembly requires two people.

Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

Tighten all parts as you assemble them, unless instructed to do otherwise.

As you assemble the weight rack, make sure all parts are oriented as shown in the drawings.

For help identifying small parts, use the PART IDENTIFICATION CHART.

The following tools (not included) are required for assembly:

• Two adjustable wrenches

• One rubber mallet

• One standard screwdriver

• One Phillips screwdriver

Lubricant, such as grease or petroleum jelly, and soapy water.

Assembly will be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches.

1.

Before beginning assembly, make sure you understand the information in the box above.

Attach the left side of the Bottom Crossbar (2) to the Base (1) without the warning decal, with two M10 x 94mm Bolts (34), a Large Joint Plate (14), and two M10 Nylon Locknuts (32). Make sure the Joint Plate is oriented as shown. Do not tighten the Locknuts yet.

Note: The Base with the warning decal applied to it should be attached on the right side of the weight rack (see WARNING DECAL PLACEMENT on page 2).

Attach the Bottom Crossbar (2) to the other Base (not shown) in the same manner.

2.Press a 60mm Square Inner Cap (22) into the back of the Lat Tower Base (3).

Attach the Lat Tower Base (3) to the Bottom Crossbar (2) with two M10 x 68mm Bolts (38) and two M10 Nylon Locknuts (32). Do not tighten the

Locknuts yet.

1

2

34

 

 

 

 

 

1

34

 

14

 

 

These holes

 

 

are closer

32

to this side

of the Plate.

32

2

3

38

22

32

2

5

Page 5
Image 5
NordicTrack NTB58030 user manual Assembly, Make Things Easier for Yourself, Locknuts yet