NordicTrack NTC4015.2 user manual Assembly

ASSEMBLY

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires the included tools and your own adjustable wrench		and Phillips screw-
driver	.

Use the part drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing is the key number of the part, from the PART LIST on page 21. The second number is the quantity needed for assembly. Note: Some small parts may have been pre-attached. If a part is not in the parts bag, check to see if it has been pre-attached.

M6 Nylon	M8 Nylon	M6 Washer	M8 Split	M4 x 16mm	M4 x 22mm
				Round Head
Locknut (72)–4	Locknut (10)–4	(88)–4	Washer (55)–14	Screw (80)–4	Screw (60)–2

	M6 x 36mm Button
M6 x 16mm Button
Screw (81)–4	Bolt (76)–4

M8 x 16mm Button	M8 x 19mm Button
Screw (54)–6	Screw (77)–4

M8 x 41mm Button

Bolt (78)–4

M8 x 50mm Button

Screw (52)–4

M10 x 63mm Bolt Set (62)–1

1. Attach the Left Front Stabilizer (15) to the left side of
	1
the Frame (1) with three M8 x 16mm Button Screws
(54) and three M8 Split Washers (55).			15
		17
Attach the Right Front Stabilizer (not shown) to the
right side of the Frame (1) in the same way.

55 55 1

54 54

4