NordicTrack NTC69023 Untie the wire and discard it, Any slack Insert the Upright 2 into the Frame

2.While another person lifts the rear of the Frame (1), attach the Rear Stabilizer (16) to the Frame with four M8 x 40mm Button Screws (54) and four M8 Split Washers (55).

3.Have another person hold the Upright (2) in the posi- tion shown. Refer to the inset drawing. Locate the wire extending from the bottom of the Upright. Tie the wire around the ends of the Wire Harness (43) and the Pulse Wire (3) as shown. Carefully pull the wire up through the Upright until the Wire Harness and the Pulse Wire are extending from the top of the Upright.

Untie the wire and discard it.	Carefully pull the ends
of the Wire Harness and the Pulse Wire to remove
any slack.
Insert the Upright (2) into the Frame (1).		Be careful to
avoid pinching the Wire Harness (43) or the Pulse
Wire (3). Attach the Upright with two M10 x 110mm
Button Screws (78) and two M10 Split Washers (88).

4.Have another person hold the Console (4) near the Upright (2).

Connect the Wire Harness (43) to the wire harness on the Console (4). Connect the Pulse Wire (3) to the pulse wire on the Console. Next, locate the two ground wires that are connected with a screw to the Upright

(2). Connect the ground wires to the two smallest wires on the Console.

Carefully insert all excess wiring down into the Upright

(2). Attach the Console (4) to the Upright with four M4

x 16mm Screws (57). Be careful to avoid pinching the wires.

6

2
	1
16
			55
	55		54
	54
3			43
			3
	2
78
88			Do not pinch the
			Wire Harness
			(43) or the Pulse
88		1	Wire (3) during
			this step.
			Wire
			43
			3
4			4
3	43
57		Ground Wires
	2		Do not pinch
			the wires
			during this step.