INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (see page 21), follow the steps below to install the receiver included with the chest pulse sensor.
Remove the access door from the underside of the Console (4). You may need to use a small standard screwdriver to remove the access door.
Slide the receiver onto the indicated plastic pin on the Console (4); make sure that the receiver is oriented
exactly as shown. Locate the two small screws included with the chest pulse sensor. Attach the receiver to the Console with the two screws as shown.
Connect the wire on the receiver to the indicated wire on the Console (4).
Reattach | the access door. | Make sure that no wires are |
pinched. | Note: The other wires included with the chest | |
pulse sensor may be discarded. |
| |
Access |
Door |
4 |
Pin |
Wire |
Receiver |
Screws |
9
