4.Lift the Upper body Arm (27) into position as shown. Be sure the Snap Buttons (40) are fully extended and
locked into position on both sides of the Hip Pad Slide (42).
5.The Console (66) requires two “AA” batteries (not includ- ed). Alkaline batteries are recommended. Refer to the
inset drawing. Locate the Battery Door (89) on the back of the Console. Slide the Battery Door to the left and open it as shown. Press two batteries into the battery compartment, with the negative ends of the batteries
touching the springs. Close the Battery Door and slide it to the right.
Attach the Console (66) to the Upper Body Arm (27) by simply pressing it into place.
6.Plug the Console Wire (47) and the Pulse Monitor (49) into the jacks on the bottom of the Console (66) as shown.
Plug the Console Wire (47) into the jack on the Upright (16).
7.Make sure that all parts are tightened before you use the ski exerciser. To protect the floor from damage, place a mat beneath the ski exerciser.
5
4 |
|
|
|
| 27 |
|
|
|
| 40 | 42 |
|
|
| |
5 |
|
|
|
| 66 |
|
|
| 27 |
|
|
| 89 | 66 |
|
| Batteries |
| |
6 |
|
|
|
| 66 |
|
|
| Pulse |
|
|
Speed | 49 |
|
|
|
|
| 47 |
|
|
| 16 |
47 |
|
|
|
