NordicTrack NTEL59012 user manual Assembly, Addition to the two, Pliers

ASSEMBLY

Assembly requires two people.		Place all parts of the elliptical crosstrainer in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.			In addition to the two
included allen wrenches, assembly requires a phillips screwdriver			, an adjustable
wrench	, a rubber mallet	, and pliers	.

As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on

page 22. The	second number refers to the quantity used in assembly.	Note: Some small parts may have been
pre-attached for	shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.

M8 Split	M8 Washer (33)–2	M10 Split
Washer (58)–2			M10 Washer (63)–2
		Washer (22)–8
M10 x 43mm Button Screw (97)–4		M8 x 19mm Screw (30)–2	M10 Nylon Locknut (26)–5
M10 x 56mm Button Screw (60)–4		M10 x 33mm Carriage Bolt (61)–2
		M10 x 85mm Bolt (25)–1

1. Identify the Rear Stabilizer (94), which has two Leveling	1	60
Feet (99) threaded into it. Turn the Rear Stabilizer so
		60
the Leveling Feet are closest to the rear of the Frame
(1) as shown. Attach the Rear Stabilizer to the Frame		22
with the four M10 x 56mm Button Screws (60) and four
M10 Split Washers (22).		1
		22
		94
		99

5