![](/images/new-backgrounds/1297996/29799611x1.webp)
2.Attach the Front Stabilizer (90) to the Frame (1) with the four M10 x 43mm Button Screws (97) and four M10 Split Washers (22). Make sure that the Front
Stabilizer is turned so the Wheels (45) are not touching the floor.
3.Slide an M8 Split Washer (58) and an M8 Washer (33) onto an M8 x 19mm Screw (30). Tighten the Screw into one end of the Incline Axle (29). Next, apply a small amount of the included grease to the Incline
Axle.
Align the indicated tubes on the Incline Frame (5) with
the tubes on the Frame (1). | Make sure that the | |
Incline Frame is turned so the | ||
are on top. | Insert the Incline Axle (29) through the |
Incline Frame and the Frame. Note: It may be helpful to tap the Incline Axle with a rubber mallet to insert it.
Slide an M8 Split Washer (58) and an M8 Washer (33) onto the other M8 x 19mm Screw (30). Tighten the Screw into the open end of the Incline Axle (29).
4.Attach the Incline Bracket (24) to the lower end of the Upright (2) with the M10 x 85mm Bolt (25) and an M10 Nylon Locknut (26). Do not overtighten the Nylon
Locknut; the Incline Bracket must be able to pivot easily.
6
2 | 97 |
|
|
| |
| 22 |
|
22 |
|
|
| 1 |
|
45 |
|
|
| 90 |
|
3 |
|
|
|
|
|
| 5 |
|
| 33 | 58 |
|
| |
|
| 30 |
Grease | 29 |
|
| Tubes |
|
33 |
|
|
58 |
|
|
30 | 1 |
|
|
| |
| Tubes |
|
4 |
|
|
| 2 |
|
24 | 26 |
|
25 |
|
|