12. Apply a generous amount of grease to the axle | 12 |
| IL |
|
on the Left Upper Body Leg (24) and to the axle |
|
| i !, |
|
on the left Crank Arm (55). Then, apply grease |
| 24 ? | i,,\, |
|
to two Large Wave Washers (102). |
| 32 | ||
|
|
| ||
|
| Grease | \\ |
|
Slide an Upper Body Leg Spacer (9) and a |
|
|
|
|
Large Wave Washer (102) onto the Left Upper |
| 102 |
|
|
Body Leg (24). Make sure that the flat side of |
|
|
| |
| 31 |
|
| |
the Upper Body Leg Spacer is facing out- |
|
|
| |
|
|
|
| |
ward, Then, slide the other Large Wave Washer |
|
|
|
|
onto the left Crank Arm (55). |
|
|
|
|
Slide the left Pedal Arm (32) onto the Left Upper | 86 | 95 |
|
|
| 32 |
|
| |
Body Leg (24) while sliding the left Link Arm |
|
|
| |
|
|
|
|
(30) onto the axle on the left Crank Arm (55).
Attach the Pedal Arm (32) to the Left Upper Body Leg (24) with an M8 x 23mm Button Screw (86), an M8 Washer (95), an Axle Cover (66), and an M8 x 23mm x 1mm Washer (31).
Then, attach the Link Arm (30) to the Crank Arm (55) with an M8 x 23mm Button Screw (86), an M8 Washer (95), a Large Axle Cover (52), and an M8 x 23mm x 1mm Washer (31).
Repeat this step for the right Pedal | 30 | |
| ||
Arm (32) and the right Link Arm (30), |
| |
See step 4. Tighten the M8 x 19mm Button | 95 | |
\ | ||
Screws (85), | Grease | |
52 | ||
| ||
| 86 |
13.Make sure that all parts of the elliptical exerciser are properly tightened, Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.
10
