Assembly
Tools required for assembly
forklift or hoist with straps/slings 14mm wrench (provided)
4 and 6mm hex wrenches (provided)
1.Remove the four screws that secure the Mortiser to the wood pallet, using a 14mm wrench.
2.With a forklift or hoist, lift the machine off the pallet and into its desired location.
3.The Mortiser should be located in a dry area, on a sturdy, level floor, and with sufficient lighting. Leave plenty of space around the machine for operations and routine maintenance work.
4.If desired, the Mortiser can be further stabilized by securing it to the floor, using lag screws through the four holes in the base.
The mortiser should be disconnected from the power source during assembly procedures.
5.Unpainted areas of the machine have been treated with a rust preventative. This should be removed with a soft cloth and a mild solvent. Do not use paint thinner, lacquer thinner, gasoline or mineral spirits; these will damage painted surfaces and plastic parts. Do not use an abrasive pad.
Installing Handle
1.Use a 4mm hex wrench to remove the screw, washer and spring from the shaft (Figure 1).
2.Mount the hub of the handle onto the shaft as shown. Make sure the hub slides all the way onto the shaft.
3.
Installing Wood Table
1.To install the wood table, first remove the right hand screw at the right of the clamp (Figure 2), with a 6mm hex wrench, and loosen the left hand screw from beneath. Pivot the clamp out of the way.
2.Mount the wood table with two flat head screws as shown.
3.
Figure 1
Figure 2
8
