3.With the help of another person, thread the console cable through the large round hole in the Handlebar
(3) and down through the Upright (2). Thread the console wire through the same hole in the Handlebar and connect it to the Extension Wire (73).
Hold the Console (4) and the Handlebar (3) near the Upright (2). Push any excess wire or cable into the Upright. Attach the Console and the Handlebar to the Upright with four M9.5 x 25mm Button Screws (51) and four M10 Lock Washers (11).
Press the Resistance Knob (46) onto the Console
(4) as shown.
4.Hold the Upright (2) in the position shown.
Refer to the inset drawing. Make sure that the indi- cated nut is threaded fully onto the connector on the Resistance Cable (40). Insert the tip of the console cable into the indicated opening, pull up on the con- sole cable, and insert the console cable into the open end of the connector. Turn the nut counter- clockwise one or two turns until the console cable is held snugly in the connector. Note: If there is a clear plastic sleeve on the Resistance Cable, position the sleeve so that it covers the connector.
Connect the Reed Switch Wire (66) to the Extension Wire (73).
Making sure not to pinch the wires or cables, slide the Upright (2) onto the Frame (1). Attach the Upright with four M10 x 25mm Button Screws (12) and four M10 Lock Washers (11).
3 |
|
| 46 |
|
|
|
|
| |
| 4 |
|
|
|
|
|
|
| Console |
|
|
|
| Wire |
|
|
|
| 3 |
|
|
|
| Console |
|
|
|
| Cable |
|
|
| 73 |
|
|
|
| 11 |
|
| 11 |
| 51 |
|
|
| 11 |
| |
|
|
|
| |
|
|
| 51 |
|
| 51 |
| 2 |
|
| 11 |
| ||
|
|
| ||
4 |
|
|
|
|
|
|
|
| Console |
|
|
|
| Cable |
| 2 |
|
| Connector |
|
|
|
| Slot |
11 | 11 |
| Nut | 40 |
|
|
| ||
12 |
| 12 |
|
|
|
|
|
| |
11 | 11 |
| Console |
|
|
|
| ||
73 |
|
| Cable |
|
|
| 40 |
| |
66 |
|
| 1 |
|
|
|
|
| |
5
