![](/images/new-backgrounds/1296834/29683417x1.webp)
MAINTENANCE AND TROUBLE-SHOOTING
Inspect and tighten all parts of the exercise cycle regularly. Replace any worn parts immediately. The exercise cycle can be cleaned with a soft, damp cloth. Avoid spilling liquid on the console. Keep the console out of direct sunlight or the display may be damaged.
TIGHTENING THE PEDALS
For the best performance, the pedals must be kept properly tightened. Regularly tighten both pedals.
BATTERY REPLACEMENT
If the console does not function properly, the batteries should be replaced. See assembly step 6 on page 6 for instructions.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the reed switch should be adjusted. In order to adjust the reed switch, the Left Side Shield (9) must be removed. Using an adjustable wrench, turn the Left Pedal (19) clockwise and remove it from the Left Crank Arm (26).
72 | 9 |
| |
| 26 |
| 72 |
19 |
|
64 | 77 |
| |
| 72 |
Next, remove the two M4 x 16mm Screws (64), the M4 x 6mm Screw (77), and the seven M4 x 38mm Screws (72) from the Left Side Shield (9). Grip both Side Shields at the top and gently pull them apart. Make sure that the Left Crank Arm (26) is in the posi- tion shown in the drawing above. Carefully slide the Left Side Shield (9) forward off the Left Crank Arm and remove it.
Locate the Reed Switch (66). Turn the Left Crank Arm
(26)until the Magnet (44) is aligned with the Reed Switch. Loosen, but do not remove, the M4 x 16mm Screw (64). Slide the Reed Switch slightly closer to or away from the Magnet. Retighten the Screw. Turn the Crank for a moment. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the Left Side Shield and the Pedal.
Front View |
26 |
44 |
64 |
66 |
HOW TO ADJUST THE DRIVE BELT
The exercise cycle features a precision belt that must be kept properly adjusted. If the belt causes exces- sive noise or slips as you pedal, the belt should be checked. To do this, the left side shield must first be removed. Refer to the instructions at the left and remove the left side shield. Next, use an adjustable wrench to turn the right pedal counterclockwise and remove it. Remove the right side shield.
Press down on |
| |
the center of the | 33 | |
Drive Belt (33) | ||
| ||
between the front |
| |
and rear pulleys. |
| |
There should be |
| |
from 1/4” to 1/2” |
| |
of vertical move- |
| |
ment in the cen- | 74 | |
ter of the Drive |
| |
Belt. If the Drive |
| |
Belt needs to be |
| |
adjusted, tighten |
|
the M8 Nylon Locknut (74). When the Drive Belt is properly adjusted, reattach the side shields and the pedals.
9