NordicTrack NTEX4196.0 user manual Assembly

ASSEMBLY

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires the included tools and your own adjustable wrench		and Phillips screw-
driver	.

Use the part drawings below to identify the small parts used in assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 21. The number following the paren- theses is the quantity needed for assembly. Note: Some small parts may have been pre-attached. If a part is not in the parts bag, check to see if it has been preattached.

M6 Washer	M8 Split		M8 Nylon	M4 x 12mm	M4 x 16mm	M6 x 16mm Button
					Round Head
(75)–4	Washer (55)–14		Locknut (60)–4	Screw (25)–1	Screw (80)–6	Screw (81)–4
M6 x 30mm Button		M8 x 16mm Button		M8 x 19mm Button	M8 x 41mm Button
Screw (37)–4		Screw (54)–6		Screw (77)–4		Bolt (45)–4
	M8 x 50mm Button			M10 x 63mm Bolt
	Screw (52)–4			Set (62)–1

1.Orient the Left Front Stabilizer (15) with the Wheel (17) in the position shown. Attach the Left Front Stabilizer to the left side of the Frame (1) with three M8 x 16mm Button Screws (54) and three M8 Split Washers (55).

Attach the Right Front Stabilizer (not shown) to the right side of the Frame (1) in the same way.

1
17		15
	55	55	1
		54
	54

4