![](/images/new-backgrounds/1297998/2979989x1.webp)
2.While another person lifts the rear of the Frame (1), attach the Rear Stabilizer (16) to the Frame with four M8 x 50mm Button Screws (52) and four M8 Split Washers (55).
3.Tighten the Upright Knob (7) into the Frame (1).
4.While another person holds the Upright (2) near the Frame (1), use the wire tie in the Upright to pull the Upper Wire Harness (42) through the Upright. See the inset drawing. Tie the end of the wire tie to the Upper Wire Harness. Then, pull the other end of the wire tie upward out of the top of the Upright. Remove and dis- card the wire tie.
Attach the Upright (2) to the Frame (1) with an
M10 x 63mm Bolt Set (62). Be careful to avoid pinching the Upper Wire Harness (42).
5.The Console (4) requires four “D” batteries
(not included); alkaline batteries are recommended. Remove the battery covers from the back of the Console. Next, insert four batteries into the battery compartments; make sure that the batteries are ori- ented as shown by the diagrams inside the battery compartments. Then, reattach the battery covers.
Note: The Console (4) can be operated with an optional power supply instead of batteries. To pur- chase a power supply, call the
2 |
|
|
|
| 1 |
|
|
| 16 |
|
|
|
| 55 | 55 |
|
| 52 | 52 |
3 |
|
| |
7 |
|
| |
|
| 1 | |
|
|
| |
4 | Avoid pinching | 42 | |
| and damaging | ||
| the wire harness. |
| |
| 2 |
|
|
|
| 62 | Wire Tie |
| 62 | 42 | |
| 1 |
| |
5 |
|
| Battery |
|
|
| Covers |
| Batteries |
|
|
| 4 |
| Batteries |
5