5.Slide the two Upright Covers (75) onto the ends of the Pulse Bar (69). Align the holes in the lower ends of the Pulse Bar with the holes in the Upright Base (85).
Cut the tie securing the Pulse Wire (74) to the Upright Base (85). Do not cut the indicated black tie. Connect the Pulse Wire to the Pulse Bar Wire (79). The connec- tors should slide together easily and snap into place. If they do not, turn one connector and try again. Insert the wires down into the right side of the Upright Base.
Hold the Pulse Bar (69) against the Upright Base (85). Do not drop the Pulse Bar into the Upright Base. Attach the Pulse Bar to the Upright Base with the four Pulse Bar Bolts (66) and four Star Washers (67). Be careful not to pinch the wires. Start all four Pulse Bar Bolts before tightening them.
Slide the Upright Covers (75) over the Pulse Bar Bolts (66).
6.Press the two Upright Covers (75) onto the Upright Base (85). Attach each Upright Cover with a 3/4” Screw (7). Be careful of the the wires in the right upright.
7.Cut the tie securing the Wires to the Upright Base (85). Have a second person hold the console assembly near the Upright Base (85). Connect the Upright Wire Harness (73) and the Pulse Wire (74) to the wires extending from the console assembly. The connectors should slide together easily and snap into place. If they do not, turn one con- nector and try again. Insert the connectors into the Console Assembly.
Connect the Upright Ground Wire (113) to the ground wire extending from the console assembly. Make sure that the wires are fully inserted into each other. Insert the ground wires into the Console Assembly.
5 |
|
| |
75 |
| 69 | |
67 |
| Do Not | |
| Cut | ||
66 | 85 | ||
| |||
79 |
| 79 | |
| 85 | ||
74 |
| ||
| 67 | ||
|
| ||
|
| 74 | |
|
| 66 | |
6 |
|
| |
Wires |
|
| |
75 |
| 75 | |
7 |
| 7 | |
|
| ||
85 |
| 85 | |
|
| ||
7 |
|
| |
Console |
|
| |
Assembly |
|
|
Ground | 74 | |
Wire | ||
|
113
74
73 
73
85 
8
