![](/images/new-backgrounds/1297910/29791011x1.webp)
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver and wire cutters
.
Note: The underside of the treadmill walking belt is coated with
For help identifying the assembly hardware, see the part drawings below.
4 1/2” Bolt | Handrail Bushing |
| |
4” Bolt | 1” Tek Screw |
|
1.With the help of a second person, carefully raise the Uprights (69) to the position shown.
See the inset drawing. Insert one of the Extension Legs
(102)into the treadmill as shown. Make sure that the Extension Leg is turned so the Base Pad (99) is be- neath it. Note: It may be helpful to tip the Uprights (69) forward as you insert the Extension Leg.
Insert the other Extension Leg (not shown) in the same way.
2.Press the Latch Knob Sleeve (70) into the left Upright (69).
Remove the Latch Knob (68) from the Latch Pin (74). Make sure that the Latch Pin Collar (72) and the Spring (71) are on the Latch Pin. Insert the Latch Pin into the Latch Knob Sleeve (70) and the left Upright (69). Press the Latch Knob Spacer (35) onto the other side of the left Upright, and then tighten the Latch Knob back onto the Latch Pin.
1 |
|
| 69 |
| 69 |
| 102 |
| 99 |
2 |
|
68 | 69 |
35 | |
| 70 |
| 71 |
| 72 |
| 74 |
6