If you purchase the optional chest pulse sensor (see page 31), follow the steps below to install the re- ceiver included with the chest pulse sensor.
1.Make sure that the power cord is unplugged. Remove the indicated Screws (99) and the two Console Screws (32) from the Console Base (98).
2.Have a second person carefully lift the pulse plates and the Console Base (98). Be careful not to pull any wires.
Connect the wire on the receiver (A) to the indicated wire extending from the Console (105). Hold the receiver so the small cylinder is oriented as shown. Then, remove the tape from the back of the receiver, and press the re- ceiver onto the Console Base (98) in the location shown.
3.While making sure that no wires are pinched, set the Console (105) on the Console Base (98). Place the pulse plates on the Console and the metal crossbar. Reattach the Console and the pulse plates with the Screws (99) and the Console Screws (32) (see step 1). Discard the other wires included with the receiver.
1 |
|
| 98 |
|
|
| |
| 99 | 99 |
|
|
|
| |
| 99 |
| |
99 |
| 32 | 99 |
2 | 105 | Pulse |
|
|
| ||
|
| Plate |
|
|
| A |
|
Pulse | Wire |
|
|
Plate |
|
| Small |
|
|
| |
|
|
| Cylinder |
|
|
| 98 |
12
