2. Have a second person hold the console assembly near | 2 |
|
|
the Upright (111). Insert the wire harness extending from |
|
| |
|
|
| |
the console assembly through the hole in the top of the |
|
|
|
Upright. Attach the console assembly to the Upright with |
|
|
|
four Console Bolts (110) and two Star Washers (114). |
|
|
|
Firmly tighten the four Console Bolts. |
|
|
|
Next, connect the wire harness extending from the con- |
|
| 108 |
sole assembly to the Wire Harness (108). The connec- |
|
| |
tors should slide together easily and snap into place. |
|
|
|
If they do not, turn one connector and try again. | Wire Harness | Console | |
| |||
|
|
| Assembly |
|
| 114 | 114 |
|
|
| 110 |
|
| 110 |
|
|
| 111 | 108 |
3. Note: For clarity, the console assembly is not shown | 3 | Notches |
|
in this step. |
| ||
|
| ||
|
|
| 112 |
Orient the Short Panel (106) so that the indicated notches |
|
|
|
are at the top. Have a second person hold the Short Panel |
|
| 101 |
against the Upright (111), with the top of the Short |
| 108 |
|
Panel flush with the top of the Upright. Firmly tighten |
|
| |
the four Upright Bolts (113). Route the Wire Harness | 109 |
| |
|
|
| |
(108) down the indicated side of the Short Panel. |
|
|
|
Next, hold the Long Panel (112) against the opposite side |
|
|
|
of the Upright (111); make sure that the top of the Long |
| 109 | 101 |
Panel is flush with the top of the Upright and that the |
| ||
Wire Harness (108) is not pinched. Press the Long |
| 106 |
|
Panel and the Short Panel (106) together, and align the | 111 |
| |
three holes in the Long Panel with the holes in the Panel |
| ||
|
|
| |
Brackets (109). Attach the Long Panel and the Short |
|
|
|
Panel with three Panel Screws (101). |
|
|
|
|
|
| 101 |
|
| 109 |
|
|
|
| 113 |
7
