If you purchase the optional chest pulse sensor (see page 26), follow the steps below to install the re- ceiver included with the chest pulse sensor.
1.Make sure that the power cord is unplugged.
2.Remove the indicated 3/4” Screw (95) and the Access Door (121) from the bottom of the Console Base (98).
3.Connect the wire on the receiver (A) to the indicated wire extending from the Console Base (98). Hold the re- ceiver so the small cylinder is oriented as shown and is facing the Console Base. Attach the receiver to the plastic posts on the Access Door (121) with the two in- cluded small screws.
4.Make sure that no wires are pinched. Reattach the Access Door (121) with the 3/4” Screw (95). Discard the other wires included with the receiver.
| Small | |
98 | Screws | |
| ||
Small | Wire | |
Cylinder | ||
| ||
121 | A | |
| ||
| 95 |
HOW TO MOVE THE TREADMILL
1.Unplug the power cord.
2.Hold the treadmill with your hands in the location shown by the arrow at the right, and raise the end of the tread- mill. CAUTION: To decrease the possibility of injury, bend your legs and keep your back straight. As you raise the treadmill, make sure to lift with your legs rather than your back.
3.Push the treadmill to the desired location. To reduce the risk of injury, use extreme caution while moving the treadmill.
4.Carefully lower the treadmill until it is resting on the floor.
Wheels |
9
