2. Attach the four Base Pads (81) to the bottom of | 2 |
|
|
the Upright (20) with the four 1” Tek Screws (82) |
|
| |
|
|
| |
in the locations shown. |
|
|
|
|
| 82 | 81 |
|
|
| |
|
|
| 81 |
|
|
| 82 |
|
| 82 |
|
|
|
| 81 |
|
|
| 20 |
|
|
| 81 |
|
|
| 82 |
3. Remove the band securing the Upright Wire | 3 |
|
|
Harness (73) to the right Upright (20). Have a |
|
| |
|
|
| |
second person hold the console assembly near |
|
|
|
the right Upright. |
|
| Console |
|
|
| Assembly |
Connect the Upright Wire Harness (73) to the |
|
|
|
console wire extending from the console assem- |
|
|
|
bly. Make sure to connect the connectors |
|
| Console Wire |
properly (see the inset drawing). The connec- |
|
|
|
tors should slide together easily and snap |
|
|
|
into place. If they do not, turn one connector |
|
| 73 |
and try again. IF THE CONNECTORS ARE NOT |
|
|
|
CONNECTED PROPERLY, THE CONSOLE |
|
|
|
MAY BE DAMAGED WHEN THE POWER IS |
|
|
|
TURNED ON. Then, insert the connectors into |
|
|
|
the right Upright (20). |
|
| 20 |
|
|
| |
|
|
| 73 |
4. Carefully set the console assembly onto the top | 4 |
| Console Assembly |
of the Upright (20) as shown. Make sure that no |
| ||
|
| ||
wires are pinched. Attach the console assem- |
|
|
|
bly to the Upright with four Star Washers (67) |
|
|
|
and four Handrail Bolts (72). Start all four |
|
|
|
Handrail Bolts before tightening them. |
|
|
|
72 
67 |
| 67 |
|
|
|
20
7
