4. Cut the plastic tie holding the Upright Wire Harness (119) | 4 |
|
| |||
in the right Upright (99). Have a second person hold the |
|
|
| |||
|
|
|
| |||
Handrails (83) near the Uprights. Connect the Upright |
|
|
|
| ||
Wire Harness to the wires extending from the Console |
|
|
|
| ||
Base (130). The connectors should slide together |
|
| 130 |
| ||
easily and snap into place. If they do not, turn one |
|
| 119 |
| ||
connector and try again. | Then, insert the connectors |
|
| |||
and the Upright Wire Harness into the hole in the right |
|
|
|
| ||
Upright. |
|
|
|
|
|
|
Set the Handrails on the Uprights, being careful not to |
|
|
| 99 | ||
pinch the wires. |
|
|
|
|
| |
|
|
|
| 83 |
|
|
5. Insert two Handrail Bolts (104) with Handrail Spacers |
| 5 |
|
| ||
(106) into the right Upright (99) and the right Handrail |
|
| ||||
|
|
| ||||
(83)Be. careful not to pinch the wires. | Make sure |
|
|
| ||
that the Handrail Spacers are flush against the right |
|
|
|
| ||
Upright, with the thick sides facing the center of the |
|
|
|
| ||
treadmill, as shown in the inset drawing. Next, lift the |
|
| 99 |
| ||
right Handrail (83) slightly and align the Bolts with the |
|
|
| |||
holes in the Handrail. Thread the Bolts into the |
| 83 | 106 | Thick | ||
Handrail. | Do not tighten the Bolts yet. |
| ||||
|
| |||||
|
|
|
|
|
| Side |
Attach the left Handrail (not shown) in the same way. |
|
|
|
| ||
Then, | tighten all four Handrail Bolts (104). |
| 106 | 104 |
| |
|
|
|
|
| ||
6. Make sure | that all | parts are properly tightened before you use the treadmill. | Keep the included allen |
wrench in | a secure | place. The allen wrench is used to adjust the walking belt (see page 29). | To protect the |
floor or carpet from damage, place a mat under the treadmill.
7
