4.Hold two Handlebar Bushings (92) around the rectangu- lar tube on the left side of the Upright (3). Slide the Left Handlebar (6) onto the Handlebar Bushings and the tube on the Upright. Attach the Left Handlebar with two M8 x 35mm Button Bolts (24), two M8 Split Washers (54), and two M8 Nylon Locknuts (28). The Nylon
Locknuts must be very tight.
Attach the Right Handlebar (5) in the same way.
5.While another person holds the Console (4) near the Upright (3), connect the console wire to the Extension Harness (77). Insert any slack wire into the Upright.
Attach the Console (4) to the Upright (3) with four Console Screws (57) and four M10 Split Washers (30).
Make sure that the console wire and the Extension Wire (77) are not pinched.
Snap the bookrack onto the Console (4) as shown.
4 |
|
|
|
| 5 |
| 92 |
|
28 |
| 3 |
|
| |
|
| 92 |
6 | 54 | 24 |
| ||
5 | 4 |
|
|
| |
|
| Bookrack |
|
| Console Wire |
|
| 77 |
30 |
|
|
|
| 3 |
| 30 |
|
57 | 57 |
|
|
|
6.Make sure that all parts of the stepper are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the stepper.
6
