NordicTrack NTTL18510 manual Move the Handrail Bolts, Bolts yet

4. Refer to drawing 4a. While another person holds the	4a
Handrails (83), thread Handrail Bolts (104) about 2-3
turns into the indicated holes in each Handrail. Then, re-		83
move the Handrail Bolts.
Refer to drawing 4b. Pinch the tabs on the Grounding
Bracket (115) so that the tabs will fit into the indicated					104
hole in the left Upright (99). Then, insert the Grounding
Bracket into the hole as far as possible.	4b
		115
Note: It may be helpful to set the Handrails (83) on the					99
Uprights (99) and loosely thread a Handrail Bolt (104)					104
into the left Upright and the left Handrail. Tip the
Handrails, if necessary, to thread in the Bolt. Have an-
other person support the Handrails while you complete
the remaining steps.
5. Pull the Upright Wire Harness (119) up through a	5			A
Handrail Spacer (116). Place the Handrail Spacer on the
				Cutout
right Upright (99) as shown, with the cutout toward the		80
treadmill (refer to inset drawing A).				116
			83
Connect the Upright Wire Harness (119) to the wires ex-
tending from the Console Base (80). Insert the connec-					99
tors and the Upright Wire Harness into the hole in the		119	99	B	119
Console Base (refer to inset drawing B).
Set the Handrail (83) on the Handrail Spacer (116), being
careful not to pinch the Upright Wire Harness (119).
		116
					80
6. Insert two Handrail Bolts (104) with Handrail Washers	6				83
(105) and Handrail Bushings (106) into the right Upright
(99) and the right Handrail Spacer (116). Turn the					116
Handrail Bushings so they fit against the Upright (refer to
			99		115
the inset drawing). Lift the right Handrail (83) slightly and
align the Bolts with the holes in the Handrail. Loosely			118
thread the Bolts into the Handrail. Do not tighten the					104
Bolts yet.			99
Refer to the inset drawing. Remove the Handrail Bolt	116		106
					105
(104) used in step 4. Place the other Handrail Spacer
(116) on the left Upright (99), with the cutout toward the
treadmill. Reach inside the left Upright and spread the
tabs on the Grounding Bracket (115) to allow a Bolt to		106
pass through the Grounding Bracket. Attach the left		105			104
Handrail (83) as described above. Make sure that the
Handrail Bushings (106) are turned properly and that the
Bolt goes through the Grounding Bracket. Tighten all
four Handrail Bolts. Press an Upright Endcap (118) into
each Upright.

7.Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 27). To protect the floor or carpet from damage, place a mat under the treadmill.

7