NordicTrack Workout TV Console user manual Power Lines

•Mount an antenna discharge unit as close as possible to where the lead-in enters the facility.

•Use a jumper wire not smaller than No. 6 AWG (13.3mm2) copper or the equivalent when a separate antenna-grounding electrode is used. See NEC Section 810-21 (j).

Note to CATV system installer: This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guide- lines for proper grounding and, in par- ticular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

Power Lines
		Ground	Standoff
		Clamp
			Insulators
Service
Entrance		To External Antenna	Mast
Conductors
		Terminal of Equipment	Antenna
Service			Lead-in Wire
Entrance		Ground	Antenna
Equipment		Wire	Discharge Unit
Power Service Grounding			Ground Wire
Electrode System (e.g.	Ground	Bonding	Ground
Interior Metal Water Pipe)	Clamps	Jumper	Clamps

Optional Antenna Grounding Electrode Driven 8 Feet (2.44 m) Into The Earth (If Required By Local Codes). See NEC Section 810–21 (f).

WARNING: Before beginning this or any exercise program, consult your physician. This is especially important for persons over the age of 35 or per- sons with pre-existing health problems. Read all instructions before using. FreeMotion Fitness assumes no responsibility for personal injury or property dam- age sustained by or through the use of this product.

SAVE THESE INSTRUCTIONS

4